1: Insert MConvoMB
2: Switch to EDIT mode
3: Move a node on the Low Pass graph.
You will notice that when you start moving it, the popup hover box will tell you the frequency as you move the node. But as soon as you let go of the mouse, it will immediately switch to DB readout, and you are no longer able to see the frequency you are moving the node to.
The only way to get it to display frequency again, is to switch to another tab (HP, Vol, or Rev B), and then switch back to LP.
This will allow you to view the freq again for ONE move, and then it reverts back to DB readout (Mimicking the Vol envelope readout, I guess).
Not sure how long this bug has been there, as I have only started using the convo, and not sure if this bug is present in any other plugins.
Will update if I find it elsewhere.
Using latest (17.02) on Win 10, FL
2: Switch to EDIT mode
3: Move a node on the Low Pass graph.
You will notice that when you start moving it, the popup hover box will tell you the frequency as you move the node. But as soon as you let go of the mouse, it will immediately switch to DB readout, and you are no longer able to see the frequency you are moving the node to.
The only way to get it to display frequency again, is to switch to another tab (HP, Vol, or Rev B), and then switch back to LP.
This will allow you to view the freq again for ONE move, and then it reverts back to DB readout (Mimicking the Vol envelope readout, I guess).
Not sure how long this bug has been there, as I have only started using the convo, and not sure if this bug is present in any other plugins.
Will update if I find it elsewhere.
Using latest (17.02) on Win 10, FL
Statistics: Posted by _al_ — Thu Nov 21, 2024 11:54 pm — Replies 0 — Views 31